Thanks to the latest update that introduces the new protocol for Marelli 11MP engine control units equipped on the Aprilia, Brixton and Moto Guzzi brands, you will be able to operate on the latest Euro5 versions.The Benchmode protocol is available that allows you to...

Thanks to the latest update that introduces the new protocol for Continental M4D engine control units equipped on the Ducati brand, you will be able to operate on the latest Euro5 versions of the iconic brand.The Benchmode protocol is available that allows you to read...

FGtech EOBD2 now supports reading and writing of Bosch EDC17C84 ecu via OBD. Previously only reading and writing in Bench and Bootmode was supported. ♦ Reading (Flash maps)♦ Writing (Flash maps)♦ Chk, Recovery Implemented vehicles list: Dacia Dokker MPV 1.5 dCiDacia...

We are excited to announce the latest update that introduces new programming protocols for CONTINENTAL/VITESCO SID321 engine control units, requested by many tuners to solve the known problems on this type of engines.The Benchmode protocol is available that allows you...

FGtechnology EOBD2 now supports reading in Bootmode for EMS2301 - EMS2302. These ECUs are equipped on 1.2 Ti-VCT petrol engines of the Ford brand. From now on it will be possible to improve the performance of this model and also it will be possible to clone the ECU in...

FGtechnology EOBD2 now supports reading in Bench and Boot mode for MED17.8.10.1 and MED17.8.10. These ECUs are equipped on 1.0 and 1.5 T-GDI petrol engines of Ford, MG and Saic brands. Reading and/or writing can be done directly via PINOUT without having to open the...

FGtech EOBD2 now supports reading and writing of all versions of Continental SID807 via OBD. Previously only writing in diagnosis was supported now full reading of flash and eeprom and writing for both versions has been implemented. ♦ Reading (Flash+Eeprom)♦ Writing...

FGtech EOBD2 now supports Benchmode reading for Bosch EGC4.0 - EDC17CB25. These control units are equipped on CNG methane engines of the G410, P410 and R410 Series. With this update we have implemented the support of control units for the Scania brand, providing a...

FGtech EOBD2 now supports Bench and Boot mode reading for Simos 8.x. These ECUs are equipped on 3.0 TFSI petrol engines Reading and/or writing can be done directly via PINOUT without having to open the ECU and in bootmode. ♦ Reading (Flash+Eeprom)♦ Writing...

FGtech EOBD2 now supports reading in Benchmode on the bench for Continental MSD80,81,85,87 & MSV90. These ECUs are equipped on BMW petrol engines for example (N43B20, N52B30, N54B30, N54B30, N63B44, N74B60, S63B44) Reading and/or writing can be done directly via...